Please remove me from your group. My need to receive information from AirVW has changed. Mike R **************New Low Prices on Dell Laptops – Starting at...
What do Kitplanes Magazine knows about hand proping and plans built airplanes and self built engines??? They only write mainly about the expensive engines used...
Building an 1835 using local suppliers for long block parts. Used Great Plains for shrink fit prop hub, 1835 cam, 1821 (Zenith) carb, u-build exhaust, X...
Recent messages on this Group have produced a number of similar complaints: The Volkswagen 'Workshop Manual' is too expensive, going for about $120 from...
I have over 500 hours on my 1835 with Bosch 009 and motorcycle battery ignition. Only time I've had an in-air charging system was in 2003 for trip to Oshkosh...
Hello Everyone, I'm new here, obvious, can anyone here give me insight and do and don'ts on the vw for my Kr2?...I just don't want to make a 10,000 ft mistake....
Just a reminder, the Alternative Engine round-up and Experimental Aircraft fly-in is coming up fast! April 28-30 http://www.contactmagazine.com/Roundup.html ...
I just bought a Rans S-6 ES with a good running Rotax 582. I've also got a 2180 VW in my shop waiting to go into a Sonex project, someday. Is anyone in the...
I have a friend looking to buy any 2-place experimental he can find, that meets the definition of LSA, that can be purchased for $5-$10k, preferably located on...
The second issue of EAA's new EXPERIMENTER is now available on line. Subscriptions are free to everyone, not just members, even though it says that it's a...
Guys, I need to get a prop flange crankshaft key for a 1/2 vw going on my minimax. Question is, is this key a special metric part or can I go to my local...
Friends, It has come to my attention that far too many people have come to the INACCURATE conclusion that EAA's rebirth of EXPERIMENTER is for members only or...
Hi everybody, I am writing from France. From where I send all my regards and wishes of success for your new President and for you all, super People of...
... From: M.Lee wachs To: vwconversions@yahoo groups.com Sent: Saturday, January 24, 2009 6:25 PM Subject: VW Engine wanted I am interested in acquireing a...
DI MASA SEKARANG EKONOMI SEDANG GAWAT JOM CARI DUIT BERSAMA SAYA. ANDA TIDAK PERLU BELI @ MENJUAL SEBARANG PRODUK DAPATKAN RAHSIA MENGHASILKAN RM5k HANYA...
Having been around the KISS method for a few years, why not someone with a 2180 and the same C/R desired, do a compression test. Then see if the one in...
Do most people in here use battery powered ignition for their VW engine in the airplane? I just didnt know if I trusted recharging a battery every day for...
I have a Hapi engine I plan to use with out the Hapi case. It appears, without taking the engine apart, there isn't any drive for the 009 distributor. Did he...
Hi Group, in the photos section I found the following picture: http://d.yimg.com/kq/groups/2870124/hr/1738777836/name/n_a I wondered if someone can tell a bit...
Hello all, Question is - do I need to play this shims and work out the Compression Ratio if I am rebuilding a stock 1600CC with stock heads pistons and ...
Ok guys, what I have is 1 full 2180 and one partial 2180. The one full 2180 has a tapered crank and prop hub, magnesium alloy case, bored and cleared, cylinder...
