Donny, Yes, Samsung and a few others are making a similar form factor to the one you referenced. It may even be a better choice for people like Jean-Claude...
Steve: It will not at first be Turn compatible, but Im informed there is a serial board to be released that allows full syncro with the spindle , so it does...
Hi: ... No. The pod will likely see the enterprising BB developers out there make up baords for it. Upside down, it looks like it would plug into a breakout ...
Hi Paul: IO is limited, its best to use an ncPod with ModIO or other input devices. Ill be looking at allowing USB printerports to be used for non-time...
Dave: Yup, probably would be.. (Ill list it for change..) Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map:...
If it provides substantially more I/O than a single PP card I'd likely buy one within the next year to upgrade my machine, which kicks rear now with Mach3 but...
Seems to be just what the doctor ordered: - Takes PC out of pulse creation stream like the G100 - 6 axis like the G100 - General I/O like most of the other...
Art - Ah... I never expected radians. Could this me made configurable? While I understand radians, I don't think I've ever seen an angle specified on a...
I have a beeter cheaper version of a UMPC (ultra mobile PC). Its from Tablet Kiosk. A EO7210. 7" touch screen. 60gig harddrive, 1gig ram 1 ghz P4 processor....
I'd be interested. Dan Mauch Camtronics Inc low cost stepper and servo motors. assembled G201,G203,G210,G320 and G340 systems ... board Ill be releasing to...
Hi Dave: Thanks, Ive been looking for that one, still looking, I hate those intermittant ones, nevr seems to happen here.. Thanks, Art www.artofcnc.ca Videos...
... under Mach3/ over the years. It's 175Mb without the Gcode folder! Actually , weve tried paring it down quite often, theres very little duplication in it....
Ok guys. For you that know me, you know I've spent the last 2 1/2 decades running a computer business, so it takes a lot to get this jaded character excited....
Art, I would certainly be interested in using these on new builds. That brings me to a question, will it support encoders for position feedback or DRO ? Eric ...
Ok, with your guide I have now on my G100 the I/O LEDs one to six light up and down . But via setup because the RESET button flash only the I/O led one and...
Dave: Thx, Ill look into the window placement, The calucator actually ruyns in Radians though, not degree's.. ( 2Pi Radians in 360 degrees..) Thanks, Art ...
I am in for one. ... board Ill be releasing to Mach3's interface, ... operational. , its specs follow.. ... there..pretty exceptional when one considers the...
... Yea - I've a lot of macros and various folders that have been created under Mach3/ over the years. It's 175Mb without the Gcode folder! There's lots of...
