The right frame casting on my Simplex has split apart. I'm needing to remove the roller drive sprocket (5" diam. with two 3/8" holes spaced 4" apart) in order...
I have a 76 triplex w/reverse, mid 60's model, for sale, moving, $300.00, email any reply to dsupik@..., located in Sykesville, MD about 30 miles west of...
Good to know I've got company with this challenge, John. I'm about to call in a pro from a local mower shop who's worked on the mower before. I'll post...
Good Morning, Locke drive sprockets are attatched by one of three ways...it is screwed on via right hand thread, keeyed with 4 woodruf keys or splined. Clean...
My early 60's locke has a left handed thread for the lock nut while the '65 model has a right handed lock nut (which is now fairly mangled). Would like to know...
I have an early 60's triplex and a mid 60's triplex. I want to switch the entire traction unit from one to the other. THe earlier model had LH threaded lock...
Many thanks to all for your advice. In removing my 60's Simplex roller drive socket, it turns out to be right-threaded onto the roller shaft, Maybe the...
I have 4 Lockes for sale in Bangor, Maine. I have had all four for many years, although they have not been run in many years. The yard at our present home is...
Try Knight's Power and Equipment - They do reel sharpening too They are in Orange, CT Sent from my Verizon Wireless 4G LTE DROID ... [Non-text portions of this...
I have a Locke 30" with some extra parts and sulky's that I would like to sell. It has the original Briggs motor and was nice to use but my lawn is too rough....
My grandfather and his two brothers owned the State Line Machine shop in Port Chester back then. That's how I got my Locke. They must have known each other....
I am running out of stuff to try, the out riggers wont lay flat on the ground. no matter how much I back off on the spring tension. Any advise. Port....
Would it be possible to post a picture of the wing and general area? To: thelockepowerreelclub@yahoogroups.com From: 11b40@... Date: Sat, 4 May 2013...
Guys, I have a 70' triplex with reverse, I recently had it sharpened (the left and center reels cut perfect) but my right hand reel cuts uneven. The reel is...
I have a Locke 75" with forward & reverse gears. Can anyone explain to me if both rollers spin in sync or more like a posi-traction action? The LEFT roller has...
Any one want to buy my 75" reel Locke? I am on Long Island. I hate to part with it but have to. Steve Sent from my iPad ... [Non-text portions of this...
Take it to J&M Mowers in RI......or call them.......401-725-8223 In a message dated 5/5/2013 10:22:15 P.M. Eastern Daylight Time, spc816@... writes: Any...
Have you tried the paper yet? The reel should not be hitting the bed knife hard. It should be adjusted to within range to cut a couple sheets of coping paper....
... In this shot you can see the right side in the air, I can hold it down with my foot while mowing...witch is not good... -- Porter Harvey (Falcon) "A"2/12...
